3 Tips for Bathtub Refinishing Troubleshooting — Drips, Sagging and Runs
Using a HVLP spray gun is a nifty way to cover a large area with paint fast and effectively…
also a great way to avoid a rough bathtub surface.
If you are doing a bathtub refinishing project that needs a lot of coating.
a HVLP sprayer is the expert approach, as you will spare an enormous amount of time and effort over roll painting by hand.
However, even though applying with spray equipment is a straightforward process.
There is still numerous things that can turn out badly with it.
These problems include dripping, sagging, and of course, runs.
Because of this, it is critical to utilize proficient processes when using bathtub refinishing spray equipment.
The following should give you enough reasons and information to avoid runs, and help you remove them when they occur…
because no one likes a rough bathtub surface.
Step 1 — Applying Coatings Correctly
The main thing that causes runs in a new finish is incorrect application.
Applying excessively will cause runs or other bathtub reglazing problems.
It is easy for an unpracticed refinish er to accidentally apply coatings too heavy.
This is because it can be difficult to judge exactly how much paint has been applied already.
The solution to this problem is to be cautious…
because it is quite difficult to remove coatings after they have been applied.
But quite easy to add more if it turns out there’s an insufficient amount applied.
When applying bathtub refinishing coatings, hold your gun approximately 6-8 inches from the surface you are spraying.
Hold it so it is oriented straight up and down.
Spray the coating evenly, never stop on a single spot.
Start by spraying the rail of the bathtub to one side to guarantee you cover everything to the edge.
Once you have applied one layer of coating to the entire surface, stop and enable the coating to dry
or you can blow with HVLP hose for a couple of moments.
You should apply up to three more coats, however you will be practically guaranteed to have an even coat…
…that is free of runs and different issues.
Step 2 — Sanding Drips and Runs
Unfortunately, it is possible to end up with one or more runs no matter how good you are at Bathtub refinishing.
When this happens, the entire project is not lost.
It is possible to eliminate runs by following the appropriate steps for bathtub refinishing troubleshooting.
Obviously, it is better to prevent any problems with the coatings in the first place, as removing them and touching up the area requires more work.
First, soak some fine-grit sand paper.
At that point, start off by sanding the problematic area to remove extra paint.
Continue to smooth the surface with fine-grit sandpaper by maintaining a strategic distance from scratching the outer surface severely.
Step 3 — Coating Touch-up
Once you have finished sanding and the bath tub feels gritty, it is likely that you will need to restore a few areas of your coating…
…during the bathtub refinishing troubleshooting process.
Essentially wipe on your bonding agent, spray a little primer followed by the new coating over the area that needs touching up.
you can use an airbrush gun or prevail sprayer.
Be extra careful to stop before paint builds up to cause runs from happening again.
Taking the time to use multiple coats is always the best idea.
A toilet or vanity cabinet that may be positioned to close to your tub during the refinishing process can interfere with the application, you will need 8 inches or more to properly apply the coatings.
If you have started a refinishing project yourself and would like expert help with bathtub refinishing troubleshooting call (423) 612-4174. Miraculous Makeovers will get your bathtub back in service in no-time.
