Are you Having Bathtub Reglazing Problems? Read Common Issues & Troubleshoot Bathtub Refinishing

If, refinishing coatings aren’t applied accurately they can make the refinishing process very complicated. This quick troubleshooting guide ought to get you progressing nicely to troubleshoot your bathtub reglazing problems and complete your bathtub refinishing project.

1. Aligatoring

if there is cracking in your coating that resembles alligator scales then aligatoring can be your concern. The solution can be as easy as removing the coating and reseal bathtub surface.

2. Bubbling

if by chance the solvents in your coating has evaporated to fast it can be the culprit of causing bubbling to appear in your finished coating. The most ideal approach to troubleshoot this issues is to sand down the coating, at that point reapply the coating at a sensible temperature.

3. Cracking

When you see splits in the finish that resembles hairline cracks, your refinished tub is suffering from cracking. To settle this issue you can either patch the damaged area or remove the failed coating and reseal bathtub surface with fresh coating.

4. Cratering

cratering are holes or deep depressions that form on the surface when bubbles break, in the event that you happened to have water or dampness in your spray gun while resurfacing it will cause the surface to crater. You can basically sand the coating down, settle the spray gun issue, at that point reapply coating.

5. Crazing

if the top layer has cured effectively yet underneath is as yet wet, it will begin to craze during the dry time. The most ideal approach to settle these cracks is to patch and sand smooth at that point reseal bath surface coating.

6. Delamination

if your top coat did not bond effectively to the surface and you loss adhesion then demalination is your issue. To troubleshoot this bathtub reglazing problems you will need to remove the top coat and primer, clean the surface then re coat.

7. Dry spray 

if your surface feels like fine coarseness sandpaper after it has been refinished then the issue was caused from dry spray. You should sand the surface and make the correct solvent adjustments to the products.

8. Flattening

when your finish doesn’t have the shine it should and you’re spraying in a high humidity area or over thinning your mixture, flattening could be the issue. Troubleshooting is simple, just re coat when surface is dry and the climate conditions are better. You additionally may need to remove the coating if the adhesion is affected then follow up with a new coat.

9. Hiding

if your top coat has a shadowy appearance and you have applied insufficient amounts of coatings then hiding is your bathtub reglazing problems. You can simply re coat and apply heavier wet coating.

10. Holidays

when there are missing areas in your coating due to surface temperatures above 90 F the cause can be holidays the easiest solution for this is to touch up missing areas with air brush gun.

Its difficult to get your tub looking like new with bathtub reglazing issues, the most ideal approach to have it dealt with is from an expert refinisher with years of experience. In my up and coming post I will go over more bath reglazing issues that you might need to find out about.